Freshman Rider
Currently Offline
[F4:http://www.face]
Posts: 84
Likes: 0
Joined: Mar 20, 2013 22:20:39 GMT -5
|
Post by armydog2010 on Jul 11, 2013 23:48:47 GMT -5
my 2008 bms tbx 260 was running great for about 5 days then it craped on me again. pile of junk!... i was riding down the road going about 55mph when it all of a sudden boged out on me. i let of throttle and it boged out and died. my fuel indicator was low so a called my wife. had fuel brought to me....its a 3.4 gal tank and i only put 1 gal in....i started it up again with no problem but the minute i gave it gas. it bogs out and if i dont release the throttle....it deos. but it will idle perfectly. any idea? fuel filter...fuel lines?
|
|
|
|
Post by scootnwinn on Jul 12, 2013 0:17:58 GMT -5
Yes check fuel supply while running/cranking. Make sure you have good flow. So yes check fuel lines vacuum lines fuel pump tank vent etc...
pull the fuel line to check flow while motor is running or starter is engaged.
Could also be clogged jets in the carb. Does it run basically daily? Or how old is the fuel in the tank?
|
|
|
|
Post by alleyoop on Jul 12, 2013 0:31:49 GMT -5
Also check your diaphgram, it may be ripped and as you open the throttle the diaphgram is not raising the needle out of the main jet so your sucking a lot of air and not enough fuel.
Alleyoop
|
|
|
|
Post by ltdhpp on Jul 12, 2013 10:25:19 GMT -5
yep, sounds like how mine ran when the needle clip broke and dropped the needle all the way down
|
|
Freshman Rider
Currently Offline
[F4:http://www.face]
Posts: 84
Likes: 0
Joined: Mar 20, 2013 22:20:39 GMT -5
|
Post by armydog2010 on Jul 12, 2013 10:35:09 GMT -5
Yes when runing I ride it Dailey to and from work. It strlarts and isles just fine but as soon as I give it throttle it bogs out and dies
|
|
Sophomore Rider
Currently Offline
2008 Roketa MC54B 257 (10,000 miles and climbing)
Posts: 103
Likes: 1
Joined: Feb 26, 2013 19:32:19 GMT -5
|
Post by bhinch on Jul 12, 2013 10:44:51 GMT -5
The valves may need to be adjusted....
|
|
Freshman Rider
Currently Offline
[F4:http://www.face]
Posts: 84
Likes: 0
Joined: Mar 20, 2013 22:20:39 GMT -5
|
Post by armydog2010 on Jul 12, 2013 11:07:25 GMT -5
Just had them adjusted a month ago
|
|
Freshman Rider
Currently Offline
[F4:http://www.face]
Posts: 84
Likes: 0
Joined: Mar 20, 2013 22:20:39 GMT -5
|
Post by armydog2010 on Jul 12, 2013 11:50:23 GMT -5
Itdhpp. U were correct. The needle clip had separated from the needle droping ut into the jet and so on so fort. I got the clip to push back on but what can I do to ensure this don't happen again? Can I super glue it or would this up the carb?
|
|
|
|
Post by scootnwinn on Jul 12, 2013 12:13:38 GMT -5
The clip shouldn't come loose perhaps it was just a crummy clip. Replace the clip with a new one.
|
|
|
|
Post by jerseyboy on Jul 12, 2013 12:32:45 GMT -5
After you put the clip on you might try to squeeze it a little with a plier to get it tighter/bend it back to its original shape...
|
|
Freshman Rider
Currently Offline
[F4:http://www.face]
Posts: 84
Likes: 0
Joined: Mar 20, 2013 22:20:39 GMT -5
|
Post by armydog2010 on Jul 12, 2013 12:41:22 GMT -5
Then its not a clip its like a washer a gold or copper ring that hold the needle
|
|
Freshman Rider
Currently Offline
[F4:http://www.face]
Posts: 84
Likes: 0
Joined: Mar 20, 2013 22:20:39 GMT -5
|
Post by armydog2010 on Jul 12, 2013 12:47:29 GMT -5
Would it help if I posted a picture?
|
|
|
|
Post by richardthescooter1 on Jul 12, 2013 13:15:23 GMT -5
Yes, post the pic and I know we can help DX
|
|
Freshman Rider
Currently Offline
[F4:http://www.face]
Posts: 84
Likes: 0
Joined: Mar 20, 2013 22:20:39 GMT -5
|
Post by armydog2010 on Jul 12, 2013 14:05:57 GMT -5
Ok stand by
|
|
|
|
Post by scootnwinn on Jul 12, 2013 15:59:31 GMT -5
Is it ok if we sit it's been a long week
|
|
..BAD TO THE BONE..
