Freshman Rider
Currently Offline
Posts: 51
Likes: 0
Joined: Apr 9, 2013 10:51:19 GMT -5
|
Post by superjew78 on Apr 10, 2013 16:32:59 GMT -5
[replyingto=bigmac]bigmac[/replyingto]Thanks for the tips, i will try both suggestions tomorrow. its pouring out now  |
|
Freshman Rider
Currently Offline
Posts: 51
Likes: 0
Joined: Apr 9, 2013 10:51:19 GMT -5
|
Post by superjew78 on Apr 9, 2013 21:49:48 GMT -5
any more suggestions?
|
|
Freshman Rider
Currently Offline
Posts: 51
Likes: 0
Joined: Apr 9, 2013 10:51:19 GMT -5
|
Post by superjew78 on Apr 9, 2013 18:56:16 GMT -5
[replyingto=superjew78]superjew78[/replyingto]scratch that, its still doing the same thing. Even after the valve adjustment. It seems to do it when you snap the throttle as the rpms drop it seems to drop really low like its going to stall out, then it starts to pick back up and idle fine.
|
|
Freshman Rider
Currently Offline
Posts: 51
Likes: 0
Joined: Apr 9, 2013 10:51:19 GMT -5
|
Post by superjew78 on Apr 9, 2013 17:32:28 GMT -5
My engine was warmed up and i was trying to do that but i couldnt seem to get it right. I think its running much better now with the valve adjustment however it still sounds a bit loud. Maybe its just louder then i remember. I just started riding it again yesterday due to better weather.
|
|
Freshman Rider
Currently Offline
Posts: 51
Likes: 0
Joined: Apr 9, 2013 10:51:19 GMT -5
|
Post by superjew78 on Apr 9, 2013 14:50:05 GMT -5
[replyingto=natetheokay]natetheokay[/replyingto]I just got done doing a valve adjustment, they were way off. I set them both to .05mm according to the guide in the sticky at the top of the forum.
Seems to be ok now but the scooter is quite louder. I am gonna dial down the idle a bit and see if its ok
|
|
Freshman Rider
Currently Offline
Posts: 51
Likes: 0
Joined: Apr 9, 2013 10:51:19 GMT -5
|
Post by superjew78 on Apr 9, 2013 10:55:49 GMT -5
From what i recall the proper way to tune the carb is to adjust the idle screw until the back wheel starts to turn, then turn back slightly till it stops. Then to adjust the idle a/f screw until it revs high. Am i wrong?
Scooter idles ok until i give it gas, once i let off the throttle the scooter idles down to the point where it is going to stall out. Sometimes it stalls and sometimes the idle will pick back up. The only way i can stop this is my turning the idle screw up to the point that the back wheel spins while idling. I am not sure what to do, any suggestions?
|
|
