|
|
Post by crawford on Oct 5, 2016 14:29:01 GMT -5
welcome from east TN
|
|
|
|
Post by crawford on Oct 3, 2016 15:23:27 GMT -5
It almost sounds like your kill switch is off or bad did you check it out first?
|
|
|
|
Post by crawford on Oct 2, 2016 19:40:46 GMT -5
If you going to keep riding you scooter a few tools you should have feeler gauges,air gauge, tire gauge, compression gauge, screwdriver set common and Phillip.
|
|
|
|
Post by crawford on Oct 2, 2016 19:34:40 GMT -5
First of all you can't use it a 14mm with a 12 mm bring it back do you not have any other other auto car part company's near you? Or a harbor Freight they sell cheep ones
|
|
|
|
Post by crawford on Sept 26, 2016 19:04:38 GMT -5
Why the Fonzie of coarse
|
|
|
|
Post by crawford on Sept 23, 2016 11:24:12 GMT -5
The old say if there is a will there is a way right raywoc
|
|
|
|
Post by crawford on Sept 22, 2016 15:29:40 GMT -5
take plug out after that insert into spark plug wire ground and crank see iff spark fires if so put a little gas into spark plug hole insert plug and crank see if it fires
|
|
|
|
Post by crawford on Sept 22, 2016 12:24:24 GMT -5
start means will not turn over or turns but won't fire up?
|
|
|
|
Post by crawford on Sept 21, 2016 19:54:56 GMT -5
Looking at picture looks like 3 screws to open it up. Maybe take it apart and maybe you can see whats wrong maybe even fix it or remover stopper and it should free flow.
|
|
|
|
Post by crawford on Sept 19, 2016 19:56:22 GMT -5
If you can fix a car now a days scoots should be a no brain er
|
|
|
|
Post by crawford on Sept 18, 2016 19:37:39 GMT -5
most testers have adapters with kit no just engage engine to do test.
|
|
|
|
Post by crawford on Sept 17, 2016 22:12:14 GMT -5
take out plug screw in compression tester crank till you get highest if over 125 psi or over that even better 150 to 165 psi great. If you take a small amount squirt a little oil in cylinder and recheck if it comes up rings are weak if no change valves need to be recheck. also you came do a hot test if you don't get burned and compared them. But if you get 150 or better you need not go further..
|
|
|
|
Post by crawford on Sept 17, 2016 22:04:14 GMT -5
What that is telling you float is hanging up or needle valve is one or other. Take float bowl off and check it out easy fix.
|
|
|
|
Post by crawford on Sept 17, 2016 15:23:05 GMT -5
some tank have a drain at bottom can you open plug drain fuel and replace plug with a screw in nipple to attach fuel hole to ?
|
|
|
|
Post by crawford on Sept 17, 2016 7:59:17 GMT -5
welcome to forum have you been doing your own maintenance on your scooters? things like that would be help full on your introduction
|
|
