Post by 99owned on Aug 11, 2013 9:19:35 GMT -5
Hey there guys, I just put on this 80cc kit for the GY6. Now, I got it on, set the valves, timing, all that good stuff, brand new carb, new coil, whole gambit. Basically got a whole boat load of parts brand new on it.
But, when I installed the BBK, It won't start...?
Has Fuel, Compression, Spark.
now, I was turning it over, and I actually got a flame out of the back of the carb.... Ermm never seen it before. So obviously, it's firing at some point, probably not the right time. -
I have adjusted the timing 8 times now. :/ Don't know what to do.
And I did line the T and the 2 dots up. with the big hole out away from the engine ^
But, when I installed the BBK, It won't start...?
Has Fuel, Compression, Spark.
now, I was turning it over, and I actually got a flame out of the back of the carb.... Ermm never seen it before. So obviously, it's firing at some point, probably not the right time. -
I have adjusted the timing 8 times now. :/ Don't know what to do.
And I did line the T and the 2 dots up. with the big hole out away from the engine ^
Main in it, using stock airbox. Uhmmm idk, I can choke it with my hand, and it will try to fire up, an occasional pop, but then it started shooting flamez.... So I just quit it out for now. Looking for suggestions... 
when my stock was 75 and thr 75 did alot better somehow 
(need 112)
-
(within that range). #
