Freshman Rider
Currently Offline
2013 Jonway MC-D23 (Roketa Aruba)
Posts: 50
Likes: 0
Joined: Mar 8, 2013 21:07:10 GMT -5
|
Post by dwayne1964 on May 24, 2013 22:13:44 GMT -5
Thanks alley. I will let you know what I find out.
|
|
|
|
Post by alleyoop on May 24, 2013 23:08:29 GMT -5
Well we are down to the wire since you have a new CDI and COIL. Now if it is the stator just get both usually the stator will come with a new pick up coil.
If it is just the Pick up coil that will save you a lot of work and not need to take the flywheel off.
Good luck and hope it is the Pick Up Coil.
Alleyoop
|
|
Freshman Rider
Currently Offline
2013 Jonway MC-D23 (Roketa Aruba)
Posts: 50
Likes: 0
Joined: Mar 8, 2013 21:07:10 GMT -5
|
Post by dwayne1964 on May 25, 2013 21:35:23 GMT -5
Well this doesn't look good. The pick up sensor which was a red white wire read .40 volts ac and the stator which was the black red wire read 21 volts ac. Now to find out which stator I need.
|
|
New Rider
Currently Offline
Posts: 23
Likes: 0
Joined: May 7, 2013 23:12:20 GMT -5
|
Post by eivad1 on May 26, 2013 18:49:42 GMT -5
alley that is what caused it, i dont have to hold my brake on to start it, i put the bulb right in and cranked right up
|
|
|
|
Post by tvnacman on May 26, 2013 18:53:22 GMT -5
the 21vac is low , was that with the electric starter ? with a fully charged battery ?
John
|
|
Freshman Rider
Currently Offline
2013 Jonway MC-D23 (Roketa Aruba)
Posts: 50
Likes: 0
Joined: Mar 8, 2013 21:07:10 GMT -5
|
Post by dwayne1964 on May 26, 2013 19:27:34 GMT -5
I had been cranking the engine quite a bit with the electric starter so I gave it a full charge before I tested the stator and pick up.
|
|
|
|
Post by tvnacman on May 26, 2013 21:45:06 GMT -5
the .4acv from the pulse coil is good , the 21vac is low . I would think the stator is bad . You might think about pulling the spark plug and redoing the readings it will spin faster with the spark plug removed .
John
|
|
Freshman Rider
Currently Offline
2013 Jonway MC-D23 (Roketa Aruba)
Posts: 50
Likes: 0
Joined: Mar 8, 2013 21:07:10 GMT -5
|
Post by dwayne1964 on May 26, 2013 22:01:22 GMT -5
Ok, I will test again tomorrow. Thanks.
|
|
Freshman Rider
Currently Offline
2013 Jonway MC-D23 (Roketa Aruba)
Posts: 50
Likes: 0
Joined: Mar 8, 2013 21:07:10 GMT -5
|
Post by dwayne1964 on May 27, 2013 19:37:38 GMT -5
Ok, did voltage checks with the plug out and they were the same.
|
|
|
|
Post by tvnacman on May 27, 2013 19:46:15 GMT -5
you need a stator
John
|
|
Freshman Rider
Currently Offline
2013 Jonway MC-D23 (Roketa Aruba)
Posts: 50
Likes: 0
Joined: Mar 8, 2013 21:07:10 GMT -5
|
Post by dwayne1964 on May 27, 2013 21:23:55 GMT -5
That's what I figured. How do I determine which one I need?
|
|
|
|
Post by tvnacman on May 28, 2013 4:58:50 GMT -5
you will need to remove the fan cover the fan the flywheel , then you will be able to see the stator .
John
|
|
Freshman Rider
Currently Offline
2013 Jonway MC-D23 (Roketa Aruba)
Posts: 50
Likes: 0
Joined: Mar 8, 2013 21:07:10 GMT -5
|
Post by dwayne1964 on May 30, 2013 19:53:43 GMT -5
Now for the next question. I was looking for a flywheel puller and seen there were a few different ones for the gy6 engines. How do I determine which one to order?
|
|
Freshman Rider
Currently Offline
2013 Jonway MC-D23 (Roketa Aruba)
Posts: 50
Likes: 0
Joined: Mar 8, 2013 21:07:10 GMT -5
|
Post by dwayne1964 on May 31, 2013 1:15:51 GMT -5
Do I need a 24 mm or a 27mm flywheel puller?
|
|
Freshman Rider
Currently Offline
2013 Jonway MC-D23 (Roketa Aruba)
Posts: 50
Likes: 0
Joined: Mar 8, 2013 21:07:10 GMT -5
|
Post by dwayne1964 on Jun 6, 2013 23:16:12 GMT -5
Finally got my stator removed. It is 6 poles. Now how do I measure the bolt hole spacing, if I measure from outside to outside of the holes it looks like 50mm.
|
|
..BAD TO THE BONE..
