|
|
Post by cyborg on Dec 17, 2015 0:53:29 GMT -5
Study hall
|
|
|
|
Post by cyborg on Dec 15, 2015 9:55:34 GMT -5
Card shark
|
|
|
|
Post by cyborg on Dec 14, 2015 9:40:06 GMT -5
Case closed
|
|
|
|
Post by cyborg on Dec 14, 2015 0:09:40 GMT -5
Cartridges misfired
|
|
|
|
Post by cyborg on Dec 13, 2015 19:58:35 GMT -5
Cam chain hitting barrel tunnel?
|
|
|
|
Post by cyborg on Dec 13, 2015 19:53:35 GMT -5
Ample endowment
|
|
|
|
Post by cyborg on Dec 13, 2015 0:48:46 GMT -5
Swapped wives
|
|
|
|
Post by cyborg on Dec 12, 2015 22:44:30 GMT -5
Stolen goods
|
|
|
|
Post by cyborg on Dec 12, 2015 16:09:07 GMT -5
I'd try and stay with the taiwan brands,,,,even used they are great
|
|
|
|
Post by cyborg on Dec 12, 2015 16:06:14 GMT -5
Just kidding calm down,,,he is a great vendor,,,,  |
|
|
|
Post by cyborg on Dec 12, 2015 16:04:32 GMT -5
he's a putz
|
|
|
|
Post by cyborg on Dec 12, 2015 15:39:46 GMT -5
I gave the rx3 the real long look,,,,if it was available as a 450-500cc i'd have one already,,,sent a few emails to them and got back "bigger displacements are in developement but as yet no release dates are anticipated",,,i have a mildly warmed up dr350 so it would have to be one he11 of a bike to top it,,,all i have to do is toss on a set of bags and the doctor would run rings around the rx,,,I read an article about the factory doing a 10,000 mile round trip on china with 8 of them,,,except for a couple tossed chains and a few flats they made it very well,,,one bike did have a bad rear wheel bearing at the end of it but that was it,,,and from the pics they posted of the ride they wern't easy on them either ,,crossing rivers ,,rocks ,, pavement you name it they threw it at them ,,but 250cc is just too small for me,,i'd even consider one if it was out a little longer and a decent jug kit was out and i'd install it and ride,,,the klx250cc is a great bike too but again too small,,,the Bill 351cc kit really wakes it up big time and some are saying it's actually a better engine and runs smoother ,,,but i have a 350 already
|
|
|
|
Post by cyborg on Dec 12, 2015 14:26:39 GMT -5
bite me,,,,,(sorry gang i couldn't resist)  |
|
|
|
Post by cyborg on Dec 11, 2015 0:51:58 GMT -5
If it were me I would rework the mount to get the caliper "in" as far as possible,,
|
|
|
|
Post by cyborg on Dec 10, 2015 23:34:13 GMT -5
Printed money
|
|
