New Rider
Currently Offline
Much Respect and Thanks to the Pros
Posts: 2
Likes: 0
Joined: Aug 11, 2016 19:54:05 GMT -5
|
Post by dansaia on Aug 11, 2016 20:26:07 GMT -5
Greetings First, I would like to offer my thanks and gratitude to everyone that helps and offers assistance on these forums, without your help I would not have got my '06 Wildfire up and running. But now, I have acquired a 2008 BMS v9 Evo in pretty good shape EXCEPT someone has the gas/vac lines all off and disconnected. There appears to be a canister PCV that was connected at one point and I don't see any type of fuel pump. I am looking for some type of diagram or schematic that can show me how to hook up all the lines. I will attach some images here and hope they help. I know I can get this running if I can figure this out. I am trying to grasp how the fuel works with the fuel tank in the front below the carb. Thanks for any help. This is what I have Carb and hoses from my scoot
|
|
|
Post by tortoise on Aug 11, 2016 20:59:13 GMT -5
|
|
|
Post by hillbillybob on Aug 12, 2016 9:59:16 GMT -5
I have the same model of scooter as you.....just a different name plate. The photo below was taken while I was doing a PDI on my scoot, prior to starting it for the first time. I removed all unecessary hoses, along with the canisters, and poop canned them. This is what it looks like after removal. My scooter has run without a single engine/drivetrain problem since purchased in 2012. Fuel pump is in upper right corner of 2nd photo, yellow line is fuel to carb inlet, black line next to it is the vacuum line, and not showing is the line to the fuel tank. I'll see if I can find more photos of original setup.
|
|
New Rider
Currently Offline
Much Respect and Thanks to the Pros
Posts: 2
Likes: 0
Joined: Aug 11, 2016 19:54:05 GMT -5
|
Post by dansaia on Aug 12, 2016 10:31:11 GMT -5
hillbillybob Thank you very much, these are great. Would you at all be able to provide me with pictures of the fuel tank lines to the fuel pump and then to the carb. I absolutely would be more than willing to pay you for your time and effort to do so as I know time is money! But I have searched and searched and cannot find these. It is important to me to do this correctly and right the first time. I am completely redoing this scoot with custom paint and all. If you provide me with a paypal email I would gladly pay you (or anyone) for detailed high res pictures of the vac lines as mentioned above. Thanks
|
|
|
Post by hillbillybob on Aug 12, 2016 10:54:55 GMT -5
These may help some.....taken before surgery was performed. Fuel pumps should be marked in and out, the third or unmarked nipple is vacuum. The only vac line needed is the one from the intake manifold that splits next to the carb.....one line goes to the air cut valve (acv) on right side of carb.....one line goes to the fuel pump. (Shown clearly in photo #2 in my first reply)
|
|