New Rider
Currently Offline
Posts: 8 
Likes: 0
Joined: Dec 19, 2014 20:02:59 GMT -5
|
Post by isaacbaker64 on Aug 4, 2016 16:48:02 GMT -5
Got a custom icebearmaddog that is havi g a no gas issue... Yes i adjusted valves still no gas it cant pump uphill... Thats the whole issue what can i do beside ride the damn gastank in my lap i even got a mikuni and still having issues but i did see the mikuni work with the send line off but its intermittent
|
|
|
|
Post by crawford on Aug 5, 2016 20:00:04 GMT -5
check vacuum line from fuel shut off with vacuum to carb and to the valve it needs to be connected to get constant fuel to carburetor are valve my be not working.
|
|
|
|
Post by JerryScript on Aug 5, 2016 20:23:47 GMT -5
Check the tank vent tube if you have one, it often goes to a charcoal canister. If that canister gets wet, it often becomes clogged. I had a tank venting issue, solved it by drilling a 1/8" hole in the gas cap, no more problems in over a year.
|
|
New Rider
Currently Offline
Posts: 8
Likes: 0
Joined: Dec 19, 2014 20:02:59 GMT -5
|
Post by isaacbaker64 on Aug 5, 2016 23:51:05 GMT -5
Okkkkk solution found the vaccume line was not sealed hardly at all on the intake tit i first got a ziptie and cranked it to with fingers that made it burp on normal turn over... A good sighn usualy had to stomp like to get it running with kickstart (yes bad i know the teeth are weak and will break off) so i usualy started with car cuz i killed batt starting. When i put a plier on it it allowed it to be semi normaland run a min when the line got hot it sealed from the pressure and bike ran great but was burping a lot and bogging on take off(still does this some with new ziptied 1/8 line wondering why) anyway got some 1/8 inch line and it is bogging verry rairly also if it matteres i got a recurring loose muffler at engine using 1/4 on all connections but intake to mikuni pump thingy thats 1/8 as mentioned before spark plug is tight and plugwire dosent read spark on tester but it runs so it must be working
|
|
