New Rider
Currently Offline
How far up the "float bowl drain valve" screw should the "float bowl drain vavle seal" be?
Posts: 7
Likes: 0
Joined: Oct 27, 2014 18:45:20 GMT -5
|
Post by grrbrts on Nov 14, 2014 10:36:19 GMT -5
The tachometer on my 2008 Roketa MC-75-150cc has quit working. I've checked the only two fuses to the scooter, one in the battery compartment and one within the front cap (open area behind the headlights). Can anyone help? |
|
|
|
Post by dmartin95 on Nov 14, 2014 12:09:12 GMT -5
There was another member on here recently that had a tach that wasn't working. Turned out to be the case that he had a broken wire. In a lot of scooters I have seen, the tachometer operates off a yellow wire with a black stripe.
Easiest way to "test" the wire is to run a jumper wire from the tach to the CDI.... If your tach starts working, I advise digging into your scoots wire harness and replace the original.
Your tach will also have a power wire, either red or black (chinese scoots use black as 12v+ on some circuits)....
If it's not a wqire, I would wager your tachometer has broken. If your tach is broke, you'll have to replace as repairing a tachometer is outside of the skillset of most on this board.
The tachometer gets it's pulse signal from the CDI to coil wire, if those were not working, your scoot wouldn't be running, so it has to be either a broken wire or a broken tach.
In short, check your tach wire, if the patch doesn't fix it, you should replace your tach.
|
|
|
|
Post by geh3333 on Nov 14, 2014 20:05:05 GMT -5
Can't give any better info then that .
|
|
