New Rider
Currently Offline
Posts: 3 
Likes: 0
Joined: Jun 29, 2014 23:05:56 GMT -5
|
Post by scottkopf on Jun 29, 2014 23:31:55 GMT -5
Recently purchased a 2010 FlyScooter (the model seems to be a Swift based on searching Internet photos) and I need the plastic cover for the engine access under the seat. I've seen some online and ordered one which is too small. The one I ordered is basically square, but the size I need is rectangular and approximately 6" x 9".
Any help would be appreciated, and I'll try to upload a photo.
|
|
|
|
Post by alleyoop on Jun 30, 2014 18:22:48 GMT -5
|
|
New Rider
Currently Offline
Posts: 3
Likes: 0
Joined: Jun 29, 2014 23:05:56 GMT -5
|
Post by scottkopf on Jul 2, 2014 23:14:46 GMT -5
Thanks! I'll give it a shot and see if it'll work.
|
|
|
|
Post by skuttadawg on Jul 2, 2014 23:57:11 GMT -5
|
|
New Rider
Currently Offline
Posts: 3
Likes: 0
Joined: Jun 29, 2014 23:05:56 GMT -5
|
Post by scottkopf on Jul 7, 2014 18:24:38 GMT -5
Ordered the one that AlleyOop suggested and it's even smaller than the first one I ordered. Hardly any parts sites have measurements, it's discouraging. About ready to give up and forget that there's storage of any kind underneath the seat.
|
|
..BAD TO THE BONE..
