Post by jjoshua20213 on Jun 5, 2014 15:57:25 GMT -5
So I got this scooter and it ran good! Just no idle and the exhaust was falling off I went to fix the exhaust and the wire that seemed to be a ground fell off, looked melted at the end and connected to nothing. Anyways I figured it was pointless and got ride of it. I adjusted the valves at the same time.
Long story short not it barely idles at a rather high idle setting(Misfiring/fluctuating idle). It uses a lot of gas, and it lost A LOT of accel. Needs to be gassed to start.
My instincts and prior knowledge short its an electrical problem.
I'm aiming at a weak spark. Can someone point me into the right direction.
I adjusted the valves around .007-8 for in and out the first time. Noticed this problem and readjusted to .005-6 with the same result.
Long story short not it barely idles at a rather high idle setting(Misfiring/fluctuating idle). It uses a lot of gas, and it lost A LOT of accel. Needs to be gassed to start.
My instincts and prior knowledge short its an electrical problem.
I'm aiming at a weak spark. Can someone point me into the right direction.
I adjusted the valves around .007-8 for in and out the first time. Noticed this problem and readjusted to .005-6 with the same result.
..BAD TO THE BONE..
