|
Post by alleyoop on Mar 16, 2013 23:29:53 GMT -5
250cm3 is equal to 8.45 ozs which is what just about every tranny takes I put in 8 ozs in mine. This may be where the fill and drain are for the tranny, see after you take the cover off. Alleyoop
|
|
New Rider
Currently Offline
Posts: 27
Likes: 0
Joined: Mar 16, 2013 17:15:35 GMT -5
|
Post by amandandme197 on Mar 16, 2013 23:31:12 GMT -5
Thanks spandi. The scooter manual on amazon is a must have. Thank you for that
|
|
New Rider
Currently Offline
Posts: 27
Likes: 0
Joined: Mar 16, 2013 17:15:35 GMT -5
|
Post by amandandme197 on Mar 16, 2013 23:34:02 GMT -5
Alleyoop, where might i have put the oil that i put in today? When the white plug was out, it was sloshing around in the hole when the wheel was moving, and stopped when the wheel stopped.
|
|
|
Post by alleyoop on Mar 16, 2013 23:34:28 GMT -5
Will do spandi, thanks much. Got ya alleyoop. Where do i get parts for this thing. Very hard to find. Triker, I did not fill it at the screw, i filled it at the white cap type screw near the rim, and there is a hose coming from close to where i filled it. It is a black hose, and then there is a clear hose that is capped off, but not going to the same spot as the black one. That black hose is the VENT for the TRANNY it has to Vent so do not plug it up. The other one that has oil in it is your crankcase vent hose and it goes into part of the airbox that usually has a foam filter for the oil. YOu have to clean that foam out so it vents. That hose with the oil drain it and plug it back up. Alleyoop
|
|
New Rider
Currently Offline
Posts: 27
Likes: 0
Joined: Mar 16, 2013 17:15:35 GMT -5
|
Post by amandandme197 on Mar 16, 2013 23:42:03 GMT -5
Is there a brake fluid fill area near the rear wheel, or just on the steering bars? What should i do since i may have put gear oil in the wrong spot? Do you want me to get you a better pic. There isnt any oil in any of the hoses, but a plug the clear hose that goes to the filter area.
|
|
|
Post by alleyoop on Mar 16, 2013 23:48:34 GMT -5
The brake fluid should be only on the Handbars TWO resovers with a little windo to see the fluid level. Yea that plugged up hose that goes to the Air Box if the overflow hose for the CRANKCASE Vent if you see a lot of oil in there unplug it and drain it. Inside the AIR BOX where that hose goes in should be a FOAM AIR FILTER you also have to clean that out ever so often.
I don't know what that place is that you put oil into, the picture is not so clear. Alleyoop
|
|
New Rider
Currently Offline
Posts: 27
Likes: 0
Joined: Mar 16, 2013 17:15:35 GMT -5
|
Post by amandandme197 on Mar 16, 2013 23:51:28 GMT -5
I got ya. I will get a real good pic for ya. If you can't get to it tonight (i know it is late and all) that is no problem. I will get it up in a bit
|
|
|
Post by alleyoop on Mar 17, 2013 0:12:01 GMT -5
Cool, Alleyoop
|
|
New Rider
Currently Offline
Posts: 27
Likes: 0
Joined: Mar 16, 2013 17:15:35 GMT -5
|
Post by amandandme197 on Mar 17, 2013 0:14:33 GMT -5
|
|
|
Post by alleyoop on Mar 17, 2013 0:24:53 GMT -5
Sorry Your cool THAT IS THE TRANNY FILL PLUG the one i put up is for the 244cc motor(DUH). Sorry your fine with the tranny oil there. Alleyoop
|
|
New Rider
Currently Offline
Posts: 27
Likes: 0
Joined: Mar 16, 2013 17:15:35 GMT -5
|
Post by amandandme197 on Mar 17, 2013 0:31:08 GMT -5
Thats good. I was worried for a while. Is it ok i filled it to the top? The worst that would happen is it would blow out the hose, right?
|
|
|
Post by spandi on Mar 17, 2013 0:32:18 GMT -5
If you call Jim At Sunright, see if he knows where you can lay you hand on a repair manual.
|
|
|
Post by alleyoop on Mar 17, 2013 0:32:30 GMT -5
Yes, that is fine it will blow out the BLACK hose and onto the ground. It is just a splash system so it will not hurt anything. Alleyoop
|
|
New Rider
Currently Offline
Posts: 27
Likes: 0
Joined: Mar 16, 2013 17:15:35 GMT -5
|
Post by amandandme197 on Mar 17, 2013 0:37:40 GMT -5
Cool spandi, i will do that. Thanks so much. Alleyoop, that is cool, i will try and get the clutch pads out as soon as i can and let you al know how it goes. Keeping my fingers crossed.
|
|
|
Post by spandi on Mar 17, 2013 0:41:52 GMT -5
|
|