|
|
Post by jeepsteve92xj on Sept 20, 2013 18:38:08 GMT -5
|
|
|
|
Post by wilds on Sept 21, 2013 2:06:00 GMT -5
|
|
|
|
Post by tvnacman on Sept 21, 2013 5:43:27 GMT -5
I wish I would have seen this in the past . Great idea!!!!!!! John |
|
|
|
Post by jeepsteve92xj on Sept 21, 2013 10:56:52 GMT -5
O had gave a short thought but never bothered to look.
thanks
what is the diameter of the gy6 flywheel?
|
|
|
|
Post by tvnacman on Sept 21, 2013 12:54:22 GMT -5
There are two sizes that I know of . ID 88mm for 8 & 11 and smaller for 6poll .
John
|
|
|
|
Post by jeepsteve92xj on Sept 21, 2013 13:06:16 GMT -5
Thanks John.
I could measure, but I am at work without a spare one laying around.
I have 11 pole on one and 12pole on the other, so I'll print a couple.
|
|
|
|
Post by tvnacman on Sept 21, 2013 16:48:31 GMT -5
Steve , the 11poll stator is 88mm the diameter of the flywheel is 89 or 90mm
|
|
Freshman Rider
Currently Offline
Posts: 88
Likes: 0
Joined: Mar 4, 2013 23:23:52 GMT -5
|
Post by woowilly on Sept 21, 2013 22:02:16 GMT -5
On the 8 pole flywheel I have that's now only good as a paperweight due to the center being trashed, I measured: 90mm ID and 111mm OD.
OD is slightly bell shaped. 110.75mm at outer edge when installed , 111.05mm at inner edge when installed.
|
|
|
|
Post by jeepsteve92xj on Sept 21, 2013 22:36:17 GMT -5
I printed one at 110mm, That should be pretty good. I was in the garage but forgot to get my 8pole magneto out to measure
|
|
