Sophomore Rider
Currently Offline
Posts: 117
Likes: 0
Joined: Mar 13, 2013 19:46:35 GMT -5
|
Post by pgs on Sept 20, 2013 17:29:18 GMT -5
i replaced my regulator last weekend and put in a new battery and was working good now the regulator is bad again worse than before before it over charged my battery now it is blowing all the lights what would cause it to go bad this quickly, not sure if this would have anything to do with it on monday i was out on it and scooter started to run terrible and pulled over and it stalled out, turned out to be loose spark plug cap,put it back on tight and started right up,i don't think that would have cooked it, when it was working good it was charging good at idle 13 volts little over 14 while revved up so it seems like the stator is working good, could it have just been a defective part?
|
|
|
|
Post by alleyoop on Sept 20, 2013 20:04:42 GMT -5
Yes, sometimes you get bad R/Rs some guys have gone through like 5 before they finally got a good one that did not go bad in a short time.(CHINA IS WERE OUR MOST QUALITY PARTS COME FROM)  Alleyoop |
|
|
|
Post by spandi on Sept 20, 2013 21:00:33 GMT -5
I got the one at the very bottom of the page. Nice quality R/R units, you should email him if you are interested to see if it (or one of them) will work in your scoot. oregonmotorcycleparts.com/VRRPM.html |
|
Sophomore Rider
Currently Offline
Posts: 117
Likes: 0
Joined: Mar 13, 2013 19:46:35 GMT -5
|
Post by pgs on Sept 24, 2013 15:20:02 GMT -5
well checked everything out and stator and ground checks out got new regulator hooked it up and blew lights, tried the original regulator other than to many volts at the battery it does not blow the lights, could it be that the regulators i got do not match up to the wires or are there that many crappy regulators out there, i went for what i thought was a better regulator and still not working
|
|
|
|
Post by tvnacman on Sept 24, 2013 16:21:12 GMT -5
4pin ?
John
|
|
Sophomore Rider
Currently Offline
Posts: 117
Likes: 0
Joined: Mar 13, 2013 19:46:35 GMT -5
|
Post by pgs on Sept 24, 2013 18:02:05 GMT -5
|
|
|
|
Post by tvnacman on Sept 25, 2013 9:17:13 GMT -5
The 4pin regulators are hit or miss . I changed the stator to 11pole and used a 7pin regulator . Then converted all my electrics to dc except for the cdi .
John
|
|
..BAD TO THE BONE..
