|
|
Post by sailracer on Jul 19, 2013 17:22:59 GMT -5
I got the exhaust gasket and installed it, fired it up all good  I had the orange coil hooked up, but not attached to the frame yet.I removed the stock coil, and bolted on the new one, Now no spark >:(no spark with the old one either. Checked all wires, look fine. Who has the diagram for the ac cdi? i need to check voltage on the terminals HELP!! |
|
Currently Offline
Posts: 0
Likes:
Joined: Nov 22, 2024 15:31:30 GMT -5
|
Post by Deleted on Jul 19, 2013 21:45:52 GMT -5
Fuse?
|
|
|
|
Post by sailracer on Jul 19, 2013 22:24:12 GMT -5
fuse isgood. connections are good  |
|
|
|
Post by devo344a on Jul 19, 2013 23:02:19 GMT -5
When you didnt have the coil bolted down it didnt have a ground and it being the higher voltage one makes it worse it will shoot all the voltage back threw the wiring and blow out the CDI.
|
|
|
|
Post by alleyoop on Jul 19, 2013 23:08:04 GMT -5
If his COIL has two wire going to it the coil is not a ground point. One of the two wires is ground.
The other thing to look for since you were messing near the valve cover is maybe you pulled accidently pulled the GROUND WIRE from the motor to the frame off.
Alleyoop
|
|
|
|
Post by sailracer on Jul 20, 2013 5:58:02 GMT -5
I wish it were that simple, but no. Wires, connectors and grounds all check out ok.
|
|
|
|
Post by sailracer on Jul 20, 2013 14:47:42 GMT -5
Update: I got an orange cdi from the local shop (the same one I tried before, and it did,nt work) i figured cause i had the extra wire on it for the speed sensor. since disconnected) anyway, I asked for another& he had an old used one hanging around. Guess what? the used one works! It doesnt seem to be rev limited because it revs high. But it takes too long. I put the 20mm carb with an  jet in, and drilled 6 3/8 " holes in the bottom of the airbox. still too slow to rev to speed. any ideas? I've already removed the 6 gram sliders, and put in the 5's |
|
|
|
Post by sailracer on Jul 20, 2013 15:31:45 GMT -5
No good, I just went on about a three mile drive & she sputtered out and died  |
|
|
|
Post by shalomrider on Jul 20, 2013 23:32:46 GMT -5
howdy, i was enjoying the conversation till the abrupt "she sputtered out and died". ----maybe a cadilacwould be more relaxing  lotsa miles and smiles to ya ken |
|
jet
..BAD TO THE BONE..
jet in, and drilled 6 3/8 " holes in the bottom of the airbox. still too slow to rev to speed. any ideas? I've already removed the 6 gram sliders, and put in the 5's