New Rider
Currently Offline
Posts: 4
Likes: 0
Joined: May 4, 2013 17:38:25 GMT -5
|
Post by barry on May 7, 2013 20:10:23 GMT -5
Really quail,
Damn, I wonder what's different. Something has to be different. Mine's a 2011 Jonway YY250Y. What about yours..? Do you know where your flasher and what it looks like..?
|
|
New Rider
Currently Offline
Posts: 4
Likes: 0
Joined: May 4, 2013 17:38:25 GMT -5
|
Post by barry on May 6, 2013 17:11:56 GMT -5
Thanks JR, The front signals if the factory bulbs are used, work fine, LED's will not. Your explanation make a lot of sense. Problem is that everyone must have a different YY250T than I do. In the other forums they post pictures of of what they have apparently have. A square 3 bottom pronged LED Flasher. If they would just go to Roketa.com, choose Scooters/Mopeds and see the electric diagram they would see at the bottom, #20. The standard YY250Y flasher unit. Kind of bums me out that no one seems to get this point. What do you think I should do..? barry  |
|
New Rider
Currently Offline
Posts: 4
Likes: 0
Joined: May 4, 2013 17:38:25 GMT -5
|
Post by barry on May 4, 2013 19:05:49 GMT -5
 HI Alleyoop, Your everywhere, cool. So far I've found 3 scoot boards and your on all three. Thanks for the answer about dash lights. That's kind of a bummer. I have several T-10'a in Green, Amber and a couple in white. I wanted to try and change the Red Dash lights to Green on one side and Amber on the other with, I foolishly assumed there is a middle light to read the instruments so a White T-10 would go there. Seems like most of my plans are dashed. I wanted to put LED's for front and back turn signals. The back work fine, the front LED signals won't work at all. And it's not polarity since turn signals ( 1156) it's a single point contact. Also my Flasher is the same one shown at Roketa.com. There are no pins on the bottom to plug into so I can't change to an LED flasher. So no cool dash lights and no front LED signals, damn...  barry
|
|
New Rider
Currently Offline
Posts: 4
Likes: 0
Joined: May 4, 2013 17:38:25 GMT -5
|
Post by barry on May 4, 2013 17:44:37 GMT -5
I want to change the RED dash lights to something else but I don't know where the bulb is. I've removed 5 T-10 bulb's from the back of the dash board on my YY250T but when I start the bike, the dash is still RED. Plus I don't know what the 5 bulbs are for.
HELP!!!!!
barry
|
|
