New Rider
Currently Offline
Posts: 2
Likes: 0
Joined: Apr 10, 2013 19:10:21 GMT -5
|
Post by maroluvr8569 on Apr 10, 2013 21:27:32 GMT -5
I did try to adjust the idle screw, but no matter where I set it, nothing changes. As far as a fuel mix, I couldn't find any sort of adjustment on the new or old carb. I was sure if you need to pull it apart and turn jets in or out for adjustment or not. I'm just beginning to get into this issue, so I haven't done a lot of tinkering. I will figure out how to adjust valves and go from there. Any other idea's or info would be great. I'll try and be timely with the work, but I currently have an old ninja torn apart that I'm trying to get back together too, so it might be hit or miss to work on the scooter. Thanks again!
|
|
New Rider
Currently Offline
Posts: 2
Likes: 0
Joined: Apr 10, 2013 19:10:21 GMT -5
|
Post by maroluvr8569 on Apr 10, 2013 19:18:55 GMT -5
hello all, i'm new to scooters and being driven nuts. i've had motorcycles and dirt bikes and such and consider myself very mechanically inclined, but this has me stumped. i bought my wife a 2011 juliet 50cc so she could start the 2 wheel training and it just will not idle. i rode it up and down the road a few times and it ran great, just shuts off when you stop. it sat for about a year before i bought it and i assumed the carb was messed up. took it off, cleaned it well, no change. bought a brand new carb from the dealer, put it on and now not only will it not idle, but it's hard starting and doesn't rev easily. i've never seen a new carb actually make something run worse. any insight anybody might have would be great. maybe it has a vaccum leak? i just don't know. thanks in advance!
chris
|
|
