New Rider
Currently Offline
Posts: 4 
Likes: 0
Joined: Feb 23, 2017 13:55:28 GMT -5
|
Post by astewart1711 on Feb 23, 2017 17:47:13 GMT -5
Yes, the vent hose is open, but even with the drain tube on it, it doesn't make a difference.
Its just weird, that when I hold my hand over the air filter (where the air is sucked in to the carb) it runs just fine until I remove my hand.
|
|
New Rider
Currently Offline
Posts: 4
Likes: 0
Joined: Feb 23, 2017 13:55:28 GMT -5
|
Post by astewart1711 on Feb 23, 2017 16:28:19 GMT -5
Got some very interesting info for you, if I plug the air intake holes, where the filter is and stuff, and give it full throttle, it seems to work JUST fine.... Then when I remove my hand from where the air is going in, my problem comes back.
Very weird... What could this indicate?
|
|
New Rider
Currently Offline
Posts: 4
Likes: 0
Joined: Feb 23, 2017 13:55:28 GMT -5
|
Post by astewart1711 on Feb 23, 2017 14:42:56 GMT -5
What do you mean valve clearance? Should I check that?
The scooter has only like 1k miles on it.... I don't think anything would break that quickly...
And where is the ignition coil connectors at? I can't find anything with slide on connectors. |
|
New Rider
Currently Offline
Posts: 4
Likes: 0
Joined: Feb 23, 2017 13:55:28 GMT -5
|
Post by astewart1711 on Feb 23, 2017 14:00:53 GMT -5
The scooter starts fine, runs fine, but when I give it a normal amount of throttle, it begins to stop or stutter... When I give it a slight amount of throttle, and leave it, it is fine...
Here is a video of me showing you what I mean, that I just recorded today.
Here is what I have tried so far:
Drained the gas, and put new gas in tank.
Tried 3 different carburetors
Any help would be wonderful, thank you!
You will have my eternal thanks for any ideas!!!!
|
|
