New Rider
Currently Offline
Posts: 19
Likes: 0
Joined: May 30, 2013 9:48:12 GMT -5
|
Post by mgsiciliano on Jun 20, 2013 11:53:23 GMT -5
Ive rejetted using a  main jet and she will run, but not well... only about 10 mph Do I need to change the airbox at all??? Drill holes? Should I try a higher jet? I have a  , 100, 105, 110 ALSO: I have the valves set to .004 on intake, and .005 for exhaust... they sould really "clicky" (more so than my other 50cc's) should I go more off feel on the 60CC valves? maybe lower than .004.... is .0025 / .003 too tight  Thanks |
|
New Rider
Currently Offline
Posts: 19
Likes: 0
Joined: May 30, 2013 9:48:12 GMT -5
|
Post by mgsiciliano on Jun 16, 2013 17:19:50 GMT -5
|
|
New Rider
Currently Offline
Posts: 19
Likes: 0
Joined: May 30, 2013 9:48:12 GMT -5
|
Post by mgsiciliano on Jun 12, 2013 9:25:48 GMT -5
Thanks guys... Ill get working on the main jet...
Any other suggestions/ issues while I wait for the order?
Also a guy told me to never full throttle a new bore kit until after a few hundred miles...
I've never heard this, but wanted to clarify
Thanks
|
|
New Rider
Currently Offline
Posts: 19
Likes: 0
Joined: May 30, 2013 9:48:12 GMT -5
|
Post by mgsiciliano on Jun 11, 2013 21:08:16 GMT -5
 So I bought this 2008 Lancesport Charming for $150 and looked get it running... I when I went to adjust the valves, I saw that the exhaust valve was not off, and upon pulling the valve case, found that the exhaust cap had broken off, and shredded the piston. I replaced the jug, piston, and the rocker arms ( with a 60cc kit ;D) ( now I'm in this scoot for total of $250) I put it all back together and hit the starter, and it turned over twice and stuck... I tried a few more time before realizing that the crank shaft was bent!!!!! After removing all of my prior work,and splitting the engine case, I successfully replaced the crankshaft. I got the entire motor back together, and replaced the carb fuel filter, and petcock for good measure. I started it, and it fires right up...idles like a champ.. But When I give it gas, it dies at 1/3 throttle... WHAT I HAVE TRIED NEW:CRANKSHAFT,PISTON,JUG,VALVEHEAD,ROCKER ARMS, CARB, FUEL FILTER, PETCOCK I have adjusted the valves everywhere from .002 to .004, adjusted the air screw on the carb.. I am out of ideas.... The only thing I can think is the main jet is too small for 60CC, but that seems unlikely... PLEASE HELP!!
|
|
main jet and she will run, but not well... only about 10 mph
, 100, 105, 110