|
|
Jet cracked
by: jtron - Jun 30, 2015 23:26:13 GMT -5
via mobile
Post by jtron on Jun 30, 2015 23:26:13 GMT -5
So I was trying out a 110 jet to see if it would add any benefit, but as I was getting it snug in the carb(hardly any pressure) the very corner of the screw slot chipped(should have used a thicker flathead) a tiny bit, a very tiny piece.. Tried it anyways and it seemed rich so I went back to the 108. Just curious to know if a veeery tiny chip off the corner of the screw slot would change how the jet works.
|
|
|
|
Post by steve on Jul 1, 2015 6:57:03 GMT -5
No, as long as the little hole that the fuel goes through is not damaged, you are fine.
|
|
|
|
Jet cracked
by: jtron - Jul 1, 2015 16:27:57 GMT -5
via mobile
Post by jtron on Jul 1, 2015 16:27:57 GMT -5
Cool, it didn't affect the hole. That's good to know thanks
|
|
New Rider
Currently Offline
Posts: 44 
Likes: 10
Joined: Apr 30, 2015 14:48:49 GMT -5
|
Jet cracked
by: stellarfoxy - Jul 2, 2015 17:57:41 GMT -5
via mobile
Post by stellarfoxy on Jul 2, 2015 17:57:41 GMT -5
I had that happen with an ebay idle jet except the whole side broke off. it ran ok but too rich so to remove it I hammered a small Phillips head screwdriver into the hole and just unscrewed it.
|
|
