(2007 E-Ton Beamer Matrix II) Looking for parts/suggestions
by: metrodee - May 18, 2014 17:15:50 GMT -5
Post by metrodee on May 18, 2014 17:15:50 GMT -5
NOTE: This was also posted in the 2-Stroke section, but I know not too many regulars on here pay attention to that section. I posted it here for that reason.
Good afternoon all...
I just recently bought a 2006 E-Ton Beamer Matrix II, 50cc 2-stroke. This is my VERY first 2-stroke scooter I've actually owned, and it runs quite amazingly for its age. Then again, it only has 4,386 miles (as of this post).
I created this thread to seek suggestions on parts as I plan to make a few mods to this scooter such as:
1. Either a 44 or 47mm BBK, whichever is the largest that can fit W/O splitting or machining cases.
2. Carb replacement
3. Reed valve replacement (saw some aluminum Reed valves on Scrappydogscooters)
4. "Expansion Chamber" pipe
5. Final drive gear upgrade
6. Clutch replacement (clutch slippage is MAJOR on this scoot, gonna replace with performance clutch)
7. CDI Replacement, if needed (according to the owner's manual, the scooter has "electronic speed limiting devices". I assume they're talking about the CDI).
I'd like to know some good places to buy the above parts or if some parts are acceptable to keep as is along with good suggestions to keep this two-stroke in good shape.
I just recently bought a 2006 E-Ton Beamer Matrix II, 50cc 2-stroke. This is my VERY first 2-stroke scooter I've actually owned, and it runs quite amazingly for its age. Then again, it only has 4,386 miles (as of this post).
I created this thread to seek suggestions on parts as I plan to make a few mods to this scooter such as:
1. Either a 44 or 47mm BBK, whichever is the largest that can fit W/O splitting or machining cases.
2. Carb replacement
3. Reed valve replacement (saw some aluminum Reed valves on Scrappydogscooters)
4. "Expansion Chamber" pipe
5. Final drive gear upgrade
6. Clutch replacement (clutch slippage is MAJOR on this scoot, gonna replace with performance clutch)
7. CDI Replacement, if needed (according to the owner's manual, the scooter has "electronic speed limiting devices". I assume they're talking about the CDI).
I'd like to know some good places to buy the above parts or if some parts are acceptable to keep as is along with good suggestions to keep this two-stroke in good shape.