Help with cylinder head bolts  By  steelace (Read 966 times)

Take one of the ones you have to the hardware store and match it up. Nearly every hardware store should have one. If you don't find the exact length one slightly too short would be better than too long...

[replyingto=steelace]steelace[/replyingto]I know they are 8mm. I'm not sure if it's 8x1.25 or 8x1.5. You should be able to get a small peice of threaded rod with the same thread.(take it with you to match it up) and simply cut it to the length you need. I would get a few nuts and washers too.
You may find that you are better off just to order a set. Then you will have some spares to keep, or give to someone else on the forum with a similar problem ;D Thats what I would do.

Thanks guys! My hardware stores dont carry any



@ Sailracer That is where I am looking. They are all 6mm thick but different lengths. I don't see any 176mm ones listed.

partsforscooters.com has single ones.they say 7mm and they have long or short ones.you should measure yours and give them a call. they are real good, and answer the phone right away.1-866-478-8700. You are looking at parts 151-133 &151-134. they are like 3 and 4.00 each.They use USPS and usually you have your item in two days
www.partsforscooters.com