New Rider
Currently Offline
Posts: 42
Likes: 1
Joined: Jul 27, 2013 10:11:03 GMT -5
|
Post by rxguy667 on Jul 29, 2013 22:14:12 GMT -5
My motor just hit 16,000 miles. I changed the reed valves today and the metal stopper I guess you would call it was closer in on these. Is there a factory measurement for these? I'm fresh into the 2T world. But so far I'm loving it!  |
|
New Rider
Currently Offline
Posts: 42
Likes: 1
Joined: Jul 27, 2013 10:11:03 GMT -5
|
Post by rxguy667 on Jul 29, 2013 22:14:30 GMT -5
50cc btw
|
|
New Rider
Currently Offline
Posts: 27
Likes: 0
Joined: Mar 16, 2013 5:09:20 GMT -5
|
Post by rune75 on Jul 30, 2013 6:33:14 GMT -5
They are almost always set at 6-8mm. I always set mine at 8mm on 50-70cc engines.
|
|
New Rider
Currently Offline
Posts: 42
Likes: 1
Joined: Jul 27, 2013 10:11:03 GMT -5
|
Post by rxguy667 on Jul 30, 2013 8:33:35 GMT -5
Where exactly do you measure it when doing this?
|
|
New Rider
Currently Offline
Posts: 27
Likes: 0
Joined: Mar 16, 2013 5:09:20 GMT -5
|
Post by rune75 on Jul 30, 2013 14:26:06 GMT -5
I measure at the end of the stopper, between the stopper and the reed blade, where the gap is widest.
|
|
