Is the cable tricky to reinstall on the carb?  By  Deleted (Read 681 times)

The most important thing, besides the length, is the way you route it. I'd take a look a how it's currently routed from one end to the other. If routed incorrectly, it may be too short to get from point A to point B--- which is what I did the first time. No big deal, just annoying. I also broke the plastic up by the throttle grips--where the cable routes through the "dash". Probably wasn't the exact metal connecting tube for the scoot either.

Undo it at both ends and tie a wire to it so when you pull it out you attach the new cable after hitting it with WD40 and fish it back through to avoid removing body panels . . It is easy to undo but darn getting the catch on the end of the cable in on the carb can be a hassle depending on its location . I chaged one 2 weeks ago for a buddy only took 4 minutes to remove it . I took the old one to my scooter dealer to match it up with another as not only length matter but if the ends are angled the same too I was told by him . Installing took longer as I had to stick my hand underneath to help it get through the cavities . I installed it on the top first but I think it would have been easier to install the bottom first since there is not much slack to insert the end plugs . Make have to adjust the barrel on the bottom at test start up as I did . It would not work but after I turned the barrel inwards then tighten up the holding nut it was good again