Check Alarm/Remote No Start  By  alleyoop (Read 645 times)

Just to make sure, you do have a ground wire from the motor to the frame?

Are you trying to start it with the remote or the KEY?

The remotes are funny If the last time you started using the remote and you shut it off using the KEY the remotes programmed seq is set to be shut off using the remote.

[blue]Here Are some things to check and try:[/blue]


[Red]#1:[/Red]
When using the remote you have to push lightning bolt twice to start the scoot.

1st Push of the button turns the ignition on.

2nd push of the button starts the scoot.

If you start the scoot without a key you have to use the "alarm unlock" to shut it off sometimes it may take 2 times then you can use key again.

PRESS THE DISARM on the remote it may be set to on by mistake.


[Red]#2:[/Red]
[Blue]CHECK THE WIRES TO JUMP:[/Blue]

Find the alarm/remote start module... trace the wires to a white plug. Unplug the plug from the wiring harness then if you have a brown/white and a black/white wire in the harness plug join them together with another wire... your scooter should start...

You might try connecting the grey and pink... if you have these colors

[Blue]OR:[/Blue]
If colors are red/white and black/red JUMP red/white to black/red on the alarm plug

Sometimes the alarms have a fuse.. Just leave it plugged into the wiring harness and remove the fuse.. It should start-up
Alleyoop