New Rider
Currently Offline
Posts: 10
Likes: 0
Joined: Mar 12, 2013 8:39:55 GMT -5
|
Post by dfg09100 on Apr 14, 2013 17:27:33 GMT -5
My new tao tao 50's blinkers dont want to work anymore. Even the indicator on the dash doesent work and front a rear. i checked dash wires and wires near engine but not rear, dont know how to pull of pladtics without braking them. Please help me. first the rear left went ouit and then all of them.
|
|
New Rider
Currently Offline
Posts: 14
Likes: 0
Joined: Apr 3, 2013 14:34:46 GMT -5
|
Post by newguy757 on Apr 14, 2013 18:55:13 GMT -5
My VIP future champ stop blinking I'm not sure why they turn on but just stays steady
|
|
Sophomore Rider
Currently Offline
Posts: 174
Likes: 1
Joined: Mar 17, 2013 11:51:20 GMT -5
|
Post by indymoped on Apr 14, 2013 19:51:06 GMT -5
I'd check your grounds. Usually when everything goes out that's what you want to check.
To remove your plastics you first have to remove the "side skirts" i think there are 2 10mm bolts and then a screw holding them to the tailight assembly and then you slide them towards the rear of the bike and they'll come off. Then remove the seat compartment and there should be a couple screws to each side of the valve cover. then take the gas cap off and the rear 3 pieces should come off together. I dont recall if you have to remove the tail lights to get some of this stuff off or not. but if you get to a point where something is hung up on the tail light assembly pull it off
|
|
New Rider
Currently Offline
Posts: 10
Likes: 0
Joined: Mar 12, 2013 8:39:55 GMT -5
|
Post by dfg09100 on Apr 14, 2013 20:42:54 GMT -5
I can try doing that. What a pain to get to haha. hope i can follow these directions.
|
|
