|
|
Post by geh3333 on Apr 13, 2024 23:08:46 GMT -5
I ordered a kit from drowsports it is the $1700 b case 232cc kit. I ran into an issue . The stroker and top end are suppose to fit without a spacer but it seems as if the cylinder studs are too long . No only do I have to use extra washers to tighten the head nuts down , but the valve cover will not fit onto the head because the studs stick out too far . I would think I would need a spacer but the timing chain is perfect length , not loose at all. I'm suspecting either wrong studs were sent or the head is somehow not the right one. I say that because the head says 63mm , not 67mm. I'll post a pic
|
|
|
|
Post by geh3333 on Apr 13, 2024 23:25:55 GMT -5
|
|
|
|
Post by geh3333 on Apr 14, 2024 0:53:50 GMT -5
|
|
New Rider
Currently Offline
Posts: 7
Likes: 1
Joined: Mar 23, 2024 21:10:39 GMT -5
|
Post by jjoshua20215 on Apr 15, 2024 19:08:33 GMT -5
Sounds like you have already identified the issue to be the incorrect size head or bolts.
My "guess" would be they cylinder head is not the correct size.
If I were you I would simply contact the seller and see what they have to say. Maybe they did mistakenly send the wrong bolts.
|
|
|
|
Post by geh3333 on Apr 28, 2024 14:58:38 GMT -5
I did contact them and they said they use that head for the 67mm builds. Doesn't seem right to me but whatever. I did get the valve cover to fit, must have been my dumbness there but I had to use extra washers to get the nut to tighten down . The head def says for use with 63mm and it has 18cc which I guess stands for 180cc . So obviously it's used with the 180cc build , so no idea , why not use a 67mm with the 67mm build ?
|
|
