New Rider
Currently Offline
Posts: 1
Likes: 0
Joined: May 8, 2024 11:51:22 GMT -5
|
Post by kain on May 8, 2024 12:01:55 GMT -5
Okay this is my first time posting so I will try to put as much info as possible.
I have a 2005 JMSTAR Falcon 150 that I picked up a few months ago. It was missing some of the electrical components and has not run since I've had it.
I bought a kit and have replaced: - solenoid - starter - stator - spark plug and coil wire - battery - regulator - DCI - carb
I have tested spark against the motor and frame, confirmed spark. I have tested compression with a quick connect threaded type and have about ninety-100psi currently. I have confirmed fuel is getting to the carb by removing the inlet hose and cranking, confirmed fuel is flowing.
If I try to start the engine cranks but never starts. Adding starting fluid into carb does absolutely nothing. Increasing throttle makes the engine run a little harder, but still never starts.
I have adjusted valves to .004 and .005. I have checked and rechecked timing.
This is my first time working on a small engine and I understand that I could just be totally missing something.
I'm honestly at a loss for what to try next and any advice would be greatly appreciated.
|
|