|
|
Post by scooter on Jan 25, 2016 16:34:11 GMT -5
I don't know how to adjust it. The service manual I found for the similar Hyosung model said "remember the settings when you take apart the carb". lol. But it was already fiddled with when I got it. It's running well on the stand but I don't want to make it overheat by making it too lean.
|
|
Freshman Rider
Currently Offline
Posts: 90 
Likes: 1
Joined: Mar 10, 2016 21:54:19 GMT -5
|
Post by vintagepgogod123 on Mar 13, 2016 17:21:06 GMT -5
I don't know how to adjust it. The service manual I found for the similar Hyosung model said "remember the settings when you take apart the carb". lol. But it was already fiddled with when I got it. It's running well on the stand but I don't want to make it overheat by making it too lean. Hyosongs been making polished turd garbage for years your best bets to measure the bolts or mount and swap with a keihin clone. If there is no adjustment screws "set the old carb on the ground eye ball it well at eye ball level take a few steps back and PUNT that ! Theres a whole pile of hysongs that have been sitting in bent bike for YEARS goes to show there dealer trash. If you find a adjusting screw, bottom ot out gentally then turn 1/8 outward at a time. Of it has one of those fat swatt back jugs on the side there is a needle in there up clip lean down clip richer. 1) adjust enrichner circuit cold 3-4 position needle. 2) air screw adjustment when hot only or after stall. 3) if no start after warm adjust the needle height attatched to throttle cable. 3-4 position. Laugh it up get fed up and drive. |
|
Freshman Rider
Currently Offline
Posts: 90
Likes: 1
Joined: Mar 10, 2016 21:54:19 GMT -5
|
Post by vintagepgogod123 on Mar 13, 2016 17:31:01 GMT -5
I don't know how to adjust it. The service manual I found for the similar Hyosung model said "remember the settings when you take apart the carb". lol. But it was already fiddled with when I got it. It's running well on the stand but I don't want to make it overheat by making it too lean. Hyosongs been making polished turd garbage for years your best bets to measure the bolts or mount and swap with a keihin clone. If there is no adjustment screws "set the old carb on the ground eye ball it well at eye ball level take a few steps back and PUNT that ! Theres a whole pile of hysongs that have been sitting in bent bike for YEARS goes to show there dealer trash. If you find a adjusting screw, bottom it out gentally then turn 1/8 outward at a time. if it has one of those fat swatt back jugs on the side there is a needle in there up clip lean down clip richer. Swatt back jug is the enrichner circuit 1) adjust enrichner circuit cold 3-4 position needle. 2) air screw adjustment when hot only or after stall. 3) if no start after warm adjust the needle height attatched to throttle cable. 3-4 position. Laugh it up get fed up and drive. |
|
