1e40 qmb-a case halves FS  By  mileage (Read 549 times)

1e40fm case halves clean, has a little surface rust on case oil seal crankshaft oil seal area. a little scratch on case halves. right sealant should seal them up. its a 1e40fm. i heard it was a qmb-a case. its like a triton bottom end, i think..? it came off a sundiro akita i think. or something like that close to it. its 90cc crankshaft cut. it ran a 54cc motor. had a stroker crank. you get everythiugn in the full picture located here, but its been took apart. have the center stand, head, no driven pulley, though uh included, .. flywheel, the alternator but the pickups bent and the stator plate where the pickup connects, is also cracked. it still seals the oil pump. the stator plate is cracked. it comes with it and the flywheel. the oil pump, comes with it. no good cylinder, also is included, i chipped a cooling fin, on the backside of the case cylinder bolt. the gears in the final drive are all there. the wheel bearings and final drive bearings are probbaly gone, and the covers bearing is gonme. thats why they stopped riding it. little surface rust in case halves. have more pics. includes, rear rim, motor mount pay shipping, its shortcase, 57mm carters, i measured them, the scratch between the case havles is like half the size of a grain of sand. i had a scratch, half that size, and i thought, it would leak. i sealed it and leak tested it and it was fine.
160 $ plus shipping OBO for all.
pics mopeddump.net78.net/mopedstuff/yclone