|
|
Post by gy6er on Feb 25, 2016 10:11:43 GMT -5
What would need to be done to fit a 150 in a short case frame 50 or would you need to start with a long case 50 to begin with? That sounds awesome to think. Power to weight would be amazing dropping 80 lbs! And I guess the wiring would work if it's AC/DC compatible. I would love a 150 with out that Hugh body and silly mount bar that really dulls down the quality of the 150 scoots. I personally would not attempt this unless it's easy but would love just to ride one.
|
|
|
|
Post by tortoise on Feb 25, 2016 14:46:00 GMT -5
Explain?
GY6 50 has bottom mounts . . 125/150 top mounts (with exception of Sym/Lance 125/150)
Roketa MC-123-150 is one of the smaller stature models with 10" wheels.
|
|
|
|
Post by gy6er on Feb 25, 2016 15:08:58 GMT -5
engine Isolation mount bar. They give allllll kinds of feed back. You should be on or off the throttle before turn when taking them because they can cause instability. 50cc BBK scoot is smooth just not near the torque.
|
|
|
|
Post by JerryScript on Feb 27, 2016 14:20:59 GMT -5
I watched it being done in the shop as my nephew's scooter was being assembled a few months back. You have to weld new mounting points to the frame, so your frame's configuration determines how complex the job would be.
There may be a kit solution, but I've only seen then for the ruckus frames.
|
|
