|
|
Post by murkyapricot on May 26, 2015 15:46:21 GMT -5
Preferably somewhere local, not really sure where to look, can't even really seem to find what I'm looking for online. I checked the local scooter place and autozone The one i have is 4inch diameter is there something else i can use preferably something stronger?  |
|
|
|
Post by keikara on May 26, 2015 19:31:34 GMT -5
|
|
|
|
Post by murkyapricot on May 26, 2015 22:44:45 GMT -5
Hmm not sure if it will fit, i just measured mine and I'm getting 94mm but i might not be getting the whole thing not the best idea to measure at nighttime
|
|
|
|
Post by keikara on May 26, 2015 22:58:45 GMT -5
Is your scoot a 50 or 150, that would be the bracket for a 150 may have different one for the 50cc
|
|
|
|
Post by murkyapricot on May 27, 2015 0:19:13 GMT -5
|
|
|
|
Post by keikara on May 27, 2015 2:05:58 GMT -5
It's hard to tell from the picture but looks to be the same size around as my stock muffler, if it is to big, but not by alot could always put an extra piece of rubber between the muffler and clamp.
|
|
|
|
Post by spandi on May 27, 2015 10:21:31 GMT -5
It says in the parts listing that there are TWO different sizes. (since 4 inches is roughly 101mm, I'd email them and find out for sure.)  |
|
|
|
Post by murkyapricot on May 27, 2015 11:01:01 GMT -5
Thanks yea im waiting for a response from them just wasnt sure if there was some generic part i could pick up somewhere
in my mind it was going to be alot easier to find then it has been so far
|
|
|
|
Post by murkyapricot on May 27, 2015 16:33:30 GMT -5
Thanks for the responses guys i found one on ebay for  -100mm What about the support bar that attaches to the scooter? I'd like to do a second clamp and contact point on the scooter towards the end of the exhaust to cut down on vibration |
|
|
|
Post by keikara on May 27, 2015 18:08:05 GMT -5
|
|
|
|
Post by murkyapricot on May 27, 2015 19:29:44 GMT -5
Yea that's the first thing i found too, have to take a few measurements to see if it will work, any idea what the use of the springs are?
|
|
-100mm