Freshman Rider
Currently Offline
Posts: 50 
Likes: 0
Joined: Aug 18, 2014 9:12:30 GMT -5
|
Post by dcustriker on Oct 8, 2014 10:07:27 GMT -5
 Here's a picture of the carb. I believe the air/fuel mixture was supposed to be on he bottom left corner. However it's just a smooth surface. Is there anywhere else the bolt could be? |
|
|
|
Post by tvnacman on Oct 8, 2014 10:19:54 GMT -5
The brass cap/plug can be removed . Then you need a screw spring washer and an or ing .
John
|
|
Freshman Rider
Currently Offline
Posts: 50
Likes: 0
Joined: Aug 18, 2014 9:12:30 GMT -5
|
Post by dcustriker on Oct 8, 2014 10:25:37 GMT -5
Are you talking about the big brass cap next to the vent hose?
|
|
|
|
Post by rockynv on Oct 8, 2014 11:42:44 GMT -5
Are you talking about the big brass cap next to the vent hose? The big one covers the end of the throttle shaft. It should be under the smaller plug. |
|
Freshman Rider
Currently Offline
Break in done.
Posts: 84
Likes: 8
Joined: Jan 26, 2014 23:57:50 GMT -5
|
Post by retrobrian on Oct 8, 2014 11:47:34 GMT -5
|
|
|
|
Post by tvnacman on Oct 8, 2014 12:18:04 GMT -5
|
|
Freshman Rider
Currently Offline
Posts: 50
Likes: 0
Joined: Aug 18, 2014 9:12:30 GMT -5
|
Post by dcustriker on Oct 8, 2014 12:32:42 GMT -5
Yea that's what I though. Will I need to drill it out? Like drill a screw in there and then pull it? Or is there an easier way?
|
|
|
|
Post by tvnacman on Oct 8, 2014 12:38:58 GMT -5
There is a video it will take me some time to find it .
John
|
|
|
|
Post by alleyoop on Oct 8, 2014 19:27:54 GMT -5
Take a 1/16 drill bit and drill the center of the plug about 1/8 only a then use a wood screw with a point on it and screw it in the hole and it will come out.
|
|
Freshman Rider
Currently Offline
Break in done.
Posts: 84
Likes: 8
Joined: Jan 26, 2014 23:57:50 GMT -5
|
Post by retrobrian on Oct 10, 2014 14:31:48 GMT -5
and dont be an idiot like me and hold the carb while drilling or , like me, you will get the bit in the palm of your hand when it slips. Dang that hurt
|
|
|
|
Post by surfpick on Oct 10, 2014 14:56:53 GMT -5
and dont be an idiot like me and hold the carb while drilling or , like me, you will get the bit in the palm of your hand when it slips. Dang that hurt I would have broken out the old shark glove:  |
|
|
|
Post by alleyoop on Oct 10, 2014 15:20:52 GMT -5
and dont be an idiot like me and hold the carb while drilling or , like me, you will get the bit in the palm of your hand when it slips. Dang that hurt OUCH!! Yep that would smarts  |
|
..BAD TO THE BONE..
