|
|
annoying
by: chris5527 - Feb 12, 2014 19:00:10 GMT -5
via mobile
Post by chris5527 on Feb 12, 2014 19:00:10 GMT -5
Ok fellas got a question, my bike is running awesome except for when I am holding it at 1/4 throttle it bogs and sputter pretty bad. Everywhere else in the throttle rang is perfect what needs to be tweaked fellas?
Edit: some info on the bike its a 2013 taotao cy50t3 with 50mm bbk, a9 cam, uni filter, blue
Fin cdi, orange performance coil, keikin carb with 95mj and stock pilot jet that came in the keihin not sure of the size.
|
|
|
|
annoying
by: chris5527 - Feb 12, 2014 19:13:04 GMT -5
via mobile
Post by chris5527 on Feb 12, 2014 19:13:04 GMT -5
It seems to me that the a/f screw is spot on it revs and comes right back down to the idle I have set, like I said the rest of the throttle range is perfect its just the initial cracking of the throttle if I hold it in that position
|
|
|
|
annoying
by: ramblinman - Feb 12, 2014 19:52:51 GMT -5
Post by ramblinman on Feb 12, 2014 19:52:51 GMT -5
it's a bit long if you want to watch the whole vid but if you watch from the 5min mark you'll see the part that i believe needs adjusting. assuming the diaphragm isn't ripped then adjusting the needle up or down will/should cure your mid-throttle range.
|
|
|
|
annoying
by: chris5527 - Feb 12, 2014 20:06:40 GMT -5
via mobile
Post by chris5527 on Feb 12, 2014 20:06:40 GMT -5
it's a bit long if you want to watch the whole vid but if you watch from the 5min mark you'll see the part that i believe needs adjusting. assuming the diaphragm isn't ripped then adjusting the needle up or down will/should cure your mid-throttle range. thank you ill check it out. the diaphragm is good had it out today thinking it might have a pin hole but checked out fin ill try lowering the c clip a notch and see if that clears it up. Thank you sir. |
|
|
|
annoying
by: chris5527 - Feb 12, 2014 20:40:55 GMT -5
via mobile
Post by chris5527 on Feb 12, 2014 20:40:55 GMT -5
So lowered the c clip one notch and she is good to go  |
|
|
|
annoying
by: ramblinman - Feb 12, 2014 21:02:19 GMT -5
Post by ramblinman on Feb 12, 2014 21:02:19 GMT -5
So lowered the c clip one notch and she is good to go  |
|
