|
|
Post by scoots on Oct 15, 2013 6:30:50 GMT -5
How do you move the needle up or down on a 4 stroke carb
|
|
|
|
Post by ltdhpp on Oct 15, 2013 11:42:02 GMT -5
Remove the top plate from your carb, remove the spring, and pull the slide/diaphragm out by the middle with your finger. There may be a plate with a screw holding the needle down in the slide, or just a plastic piece that is held down by the spring. Note any washers or o-ring you may or may not find, so you put them back right. If it is adjustable, there will be a clip you can pull out at the top of the needle and several notches you use to make the adjustment.
|
|
|
|
Post by scoots on Oct 15, 2013 12:29:27 GMT -5
Up r down
|
|
|
|
Post by millsc on Oct 15, 2013 14:02:12 GMT -5
Moving the clip up drops the needle
|
|
|
|
Post by alleyoop on Oct 15, 2013 14:05:30 GMT -5
Moving the Clip Up Leans the Mid Range and Moving the Clip Down Richens the Mid Range.
Alleyoop
|
|
|
|
Post by scoots on Oct 15, 2013 14:46:45 GMT -5
Having trouble gettng my needle out from the diaphragm it looks like a plasic screw after u take spring out
|
|
|
|
Post by skuttadawg on Oct 15, 2013 23:26:06 GMT -5
|
|
|
|
Post by scoots on Oct 16, 2013 6:02:15 GMT -5
Having trouble gettng my needle out from the diaphragm it looks like a plasic screw after u take spring out
|
|
..BAD TO THE BONE..
