Yun ba alarm removal  By  lostforawhile (Read 3,304 times)

If you've been cursed by a Chinese yun bar alarm, that is malfunctioning, I've traced out the kill switch wires that need to be jumped, if you unplug the alarm, the key switch will no longer kill the engine,as the key kill wire,routes through it. This is for most sunny type scooters,most harnesses are the same, and these yun ba alarms should be the same, on the bike harness side,there should be a black with a white stripe, and a brown with a white stripe,right next to each other, one wire goes to the kill switch circuit and cdi, and one wire comes from ignition kill on the key switch (grounds when key is off) don't cut the plug off,if you ever want a real alarm,every connection you need,is in there, if you are going to trash the yun ba, cut off its connector,as close to the case as you can, save the pigtail, on the pigtail,there should be a gray wire,and a pink wire, they should match the previously mentioned wires, by plugging this in,you have connected the key switch kill,to the kill circuit, I strongly advise hiding a kill switch somewhere on the bike,as I'm sure all thieves know,by unplugging the connector, the bike kick starts without a key, or unplugging the key switch and kick starting.