Post by mark2275 on Feb 18, 2014 1:00:19 GMT -5
read all of this first before you get started you might want to put some of those screws back in. If it's a VIP after you remove the seat and bucket together. you remove the rack from the rear then you pull up on the front panel that is bowed that seat bucket was attached to that had the 1 big Phillips head screw. it is clicked in about 4 or 5 places into the floor board. push the whole rear body assembly back about 1 inch back and lift away from the scooter. it might be a little tight due to wiring on the right side, and the rear fender fits up under the side panels by tail light that is why you have to slide it back and lift. if you take it off in 1 piece it is easier to control and you shouldn't break any plastic. reassemble in reverse sliding over top of tail light make sure lock trigger is in place and works. then tucking fender back up into body panels then click front panel to floor board. re- install seat assembly you should be good to go. 